maximum error

The principle of the analog-digital composite compensation technique is described and the factors causing fitting errors arc analyzed. The formula for calculating the maximum error is derived.

还叙述了模-数混合补偿技术的工作原理，分析了引起拟合误差的因素并推导出计算最大误差的公式。

互联网摘选

The maximum error due to omitting mathematical model detail, is less than 0.1%.

忽略数学模型的细节所招致的最大误差小于0.1%。

互联网摘选

The maximum error of rectified number of sun and moon appears only when the sun and the moon run near perigee at the same time.

日月改正数误差最值仅出现在太阳和月亮同时运行至近地点附近时。

互联网摘选

The results from accuracy and precision tests of the instrument show that the maximum error in Raman peak position measurement is ± 1 cm-1.

经对仪器准确性和精密度的测定表明，测定拉曼峰位的最大偏差为±1cm－1。

互联网摘选

Compared calculated values used these models with experimental results, average error is 2.48%, and maximum error is 7.87%.

使用该模型计算出的结果与实测值相比，平均误差2.48%，最大误差7.87%。表明该模型具有较高的合理性和实用性。

互联网摘选

First to analysis the experimental signal measurement error, it increases as the percentage of liquid increases and the maximum error is 14%.

主要完成内容如下：1、对实验采集的信号进行了误差分析，测量误差随着液相含率的增加而增加，最大测量误差为14%。

互联网摘选

Results: The accuracy of CT localization of BRW headring was 0.65 mm and maximum error was 1.09 mm.

结果：CT平均定位误差0.65mm，最大误差1.09mm。

互联网摘选

According to the results in this experiment, based on the similarity between flash evaporation and nuclear boiling, an experimental expression of heat transfer coefficient with all of the influence parameters was presented with the maximum error of 27%.

根据实验结果，基于闪蒸过程类似核态沸腾，给出了换热系数与各影响参数之间关系的实验关联式，与实验结果的误差小于27%。

互联网摘选

The average error rate is 1.21 percent and the maximum error rate 2.73 percent, the accuracy of imitation is very high.

对全国总人口序列采用柯布&道格拉斯函数模型进行增量序列拟合建模，在中间变量层次中揭示出周期性变化规律，拟合效果极显著，平均误差率1.21%，最大误差率2.73%，拟合精度极高。

互联网摘选

The maximum error is equal to 0.781%.

最大的误差为0.781%。

互联网摘选

Additionally, admissible values of system error, the average error and the maximum error in the middle surface are proposed.

同时，结合算例分析，总结出了坝体系统误差、中面平均误差和中面最大误差的容许值。

互联网摘选

Results: The accuracy of CT localization of BRW headring was 0.65? mm and maximum error was 1.09?

结果：BRW头环CT定位精度为0.65mm，最大误差为1.09mm；

互联网摘选